Skip to the content

Hours Calculator

Add up working hours from start and end times, minus breaks.

  • 8:00 8.00
  • 7:45 7.75
Total
15:45
hours:minutes, 2 rows
As a decimal
15.75
hours
Pay
–
enter an hourly rate
$

Add or subtract durations

Hours and minutes (2:45), decimal hours (1.5) or minutes (90m), with + and - in between.

Result

3:55

3.92 hours as a decimal, 235 minutes

Share this tool:TwitterFacebookLinkedInWhatsAppEmail

Minutes are not decimals

A total of 7:30 means 7 hours and 30 minutes, which is 7.5 hours. Writing it down as 7.3 is a common mistake on timesheets, and not a small one: at 20 an hour, 7.5 hours pays 150 and 7.3 hours pays 146.

To turn minutes into a decimal, divide them by 60. To go back, multiply the part after the point by 60: 7.3 hours is 7 hours and 0.3 × 60 = 18 minutes.

MinutesDecimal hours
50.08
100.17
150.25
200.33
300.50
400.67
450.75
500.83

The calculator shows every row and the total both ways. Decimals are rounded to two places. The pay is worked out from the exact minutes, so it can differ a little from the rounded figure times your rate: 7:20 at 15 an hour is 110.00, while 7.33 × 15 is 109.95.

How a row is counted

End time minus start time, minus the break. From 09:00 to 17:30 is 8 hours 30 minutes; with a break of 30 minutes that leaves 8:00.

An end time that is earlier than the start time means the shift ran past midnight: 22:00 to 06:00 is 8 hours. The row then says "ends the next day", so that a typing mistake does not go unnoticed. A row cannot be longer than 24 hours, and the same start and end time counts as zero.

The break is in minutes. 0:45 and 1h are understood as well.

The timesheet knows times, not dates. Where daylight saving time is used, a night shift on the night the clocks change is an hour shorter or longer than its start and end times suggest, and you have to correct that yourself.

What it leaves out

Rounding to the quarter hour, overtime rates, night and weekend supplements and the rules about paid and unpaid breaks differ per employer and per country. None of them are applied here. The total is the time between the clock times you entered, and the pay is that total times one rate, before tax.

Adding and subtracting durations

The second box adds up lengths of time instead of clock times. Each part can be written as hours and minutes (2:45), as decimal hours (1.5 or 1,5), in minutes (90m) or mixed (1h 30m). A number without a unit means hours. So 2:45 + 1:30 - 0:20 gives 3:55, which is 3.92 hours or 235 minutes.

See all 9